how to mount wd my passport mac on linux

mount) via a powered hub I had to power the hub with an 'ILuv' 5V 2A PSU. I have a DVD drive which uses a Y lead and works fine if plugged into two ports of my netbook (it was originally supplied with a Medion laptop some years ago).

looking into the 'Devices and printers' window an exclamation mark is placed on 'My Passport' device saying that ' the driver for. In MS windows, it also takes a long time to be visible. (More detail can be found in my webpages - see link on the right). Linux (Fedora) reports( after about 3-4 minutes from mounting the disk) hard disk failure, that some sectors are being dislocated and something about mapping.

However, virtually all of the hubs measured had the 'power connections' of their ports connected in parallel - hence all the Y cable does is give you a little reduction in the combined connector/cable resistance. 'state' that each port can supply up to 500mA (hence the Y cable to connect to two ports). Many external disk drives need at least 1 amp on 'spin-up' and the PSU/hub combination has to be able to provide this. The dual usb (Y) cord may have helped a little but, in my experience, and based upon measurements of the loading performance and inter-connectivity of the ports of a number of 'powered hubs' (albeit 'low-cost' ones) it's the hub's PSU that's the 'critical' component.

How to mount wd my passport mac on linux